Virtual Network Phase Detection Control (Gdu_Phasectrl) - NXP Semiconductors MC9S08SU16 Reference Manual

Field
0 High-Side pre-driver Drive Output Pulldown Enable
PDE
0 Disables the pulldown.
1 Enables the pulldown.

25.6.15 Virtual Network Phase Detection Control (GDU_PHASECTRL)

V is the comparator of minus input from DAC, ADC or
INM
virtual Neutral.
Address: 20h base + 1852h offset = 1872h
Bit 7
Read 0
Write
Reset 0
Field
7 This field is reserved.
Reserved This read-only field is reserved and always has the value 0.
6 Virtural Network Enable
VNEN
0 Virtual resistor network disabled.
1 Virtual resistor network enabled.
5 Virtual Neutral Internal Connection
INTSEL
0 INTSEL MUX disabled .
1 INTSET MUX enabled, virtual neutral is connected to the internal 6-bit DAC in the CMP module.
4 Virtual Neutral External Connection
EXTSEL
0 EXTSEL MUX disabled.
1 EXTSET MUX enabled, virtual neutral is connected to the external pin.
3 This field is reserved.
Reserved This read-only field is reserved and always has the value 0.
2 Virtual Network Phase 2 Selection
PHSEL2
0 Phase 2 is off.
1 Phase 2 is on.
1 Virtual Network Phase 1 Selection
PHSEL1
NXP Semiconductors
GDU_IOCTRL field descriptions (continued)
NOTE
6 5
VNEN INTSEL EXTSEL
0 0
GDU_PHASECTRL field descriptions
Table continues on the next page...
MC9S08SU16 Reference Manual, Rev. 5, 4/2017
Description
4 3
0
PHSEL2
0 0
Description
Chapter 25 Gate Drive Unit (GDU)
2 1
PHSEL1 PHSEL0
0 0
0
0
451