Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide A to M
ipv6 nd reachable-time
Syntax
Release Information
Description
Options
Mode
1070
ipv6 nd reachable-time { milliseconds | hours minutes seconds }
no ipv6 nd reachable-time
Command introduced before JunosE Release 7.1.0.
Profile Configuration mode added in JunosE Release 9.0.0.
Specifies the amount of time that the E Series router can reach a remote IPv6 node after
some reachability confirmation event has occurred. The no version restores the default
value 0 milliseconds for router advertisements and 3,600,000 milliseconds (1 hour) for
Neighbor Discovery activity of the E Series router.
milliseconds—Amount of time, in the range 0–21600000 milliseconds, that the E Series
router can reach a remote node after some reachability confirmation event has occurred
hours minutes seconds—Amount of time, in the range 0 hours 0 minutes
0 seconds – 6 hours 0 minutes 0 seconds, that the E Series router can reach a remote
node after some reachability confirmation event has occurred; this specification is not
supported in Profile Configuration mode
Interface Configuration, Profile Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
