ADTRAN AOS Version R10.1.0 Command Reference Manual page 2586

Command Reference Guide
username <username> password <password>
Use the username password command to configure the user name and password of the peer to use for
Point-to-Point Protocol (PPP) authentication. Use the no form of this command to remove a configured
user name and password.
Syntax Description
<username>
<password>
Default Values
By default, there is no established user name and password.
Command History
Release 1.1
Functional Notes
Password Authentication Protocol (PAP) uses this entry to check received information from the peer.
Challenge-Handshake Authentication Protocol (CHAP) uses this entry to check the received peer host
name and a common password.
Usage Examples
The following example creates a user name of ADTRAN with password ADTRAN for the PPP link
labeled 5:
(config)#interface ppp 5
(config-ppp 5)#username ADTRAN password ADTRAN
60000CRG0-35E
Specifies a user name by alphanumerical string up to 30 characters in
length (the user name is case sensitive).
Specifies a password by alphanumerical string up to 30 characters in length
(the password is case sensitive).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
PPP Interface Command Set
2586