Table 26.2 Dc Characteristics (3) Using Lpc Function - Renesas H8S Series Hardware Manual

Notes: 1. Do not leave the AVCC, AVref, and AVSS pins open even if the A/D converter is not used.
Even if the A/D converter is not used, apply a value in the range from 3.0 V to 3.6 V to the AVCC
and AVref pins by connection to the power supply (V
should be AVref ≤ AV
2. Includes peripheral module inputs multiplexed on the pin.
3. IRQ2 includes the ADTRG input multiplexed on the pin.
4. Ports A, G, P97, P86, P52, P42, and peripheral module outputs multiplexed on the pin are NMOS
push-pull outputs.
An external pull-up resistor is necessary to provide high-level output from SCL0, SCL1, SDA0,
SDA1, ExSCLA, ExSCLB, ExSDAA, and ExSDAB (ICE bit in ICCR is 1).
Ports A, G, P97, P86/SCK1, P52, and P42/SCK2 (ICE bit in ICCR is 0) high levels are driven by
NMOS. An external pull-up resistor is necessary to provide high-level output from these pins when
they are used as an output.
5. Indicates values when ICCS = 0, ICE = 0, and KBIOE = 0. Low level output when the bus drive
function is selected is rated separately.
6. Current consumption values are for V
unloaded and the on-chip pull-up MOSs in the off state.

Table 26.2 DC Characteristics (3) Using LPC Function

Conditions: V = 3.0 V to 3.6 V, V
CC
Item
Input high voltage
P37 to P30
P83 to P80, PB1, PB0
Input low voltage
P37 to P30
P83 to P80, PB1, PB0
Output high voltage P37, P33 to P30,
P82 to P80. PB1, PB0
Output low voltage
P37, P33 to P30,
P82 to P80. PB1, PB0
.
CC
min = V
IH
= 0 V
SS
Symbol Min.
V
IH
V
IL
V
OH
V
OL
Section 26 Electrical Characteristics
). The relationship between these two pins
CC
– 0.2 V and V max = 0.2 V with all output pins
CC IL
Max. Unit

V × 0.5
V
CC

V × 0.3
V
CC

V × 0.9
V
CC

V ×0.1
V
CC
Rev. 3.00 Jul. 14, 2005 Page 951 of 986
Test Conditions
I = –0.5 mA
OH
I = 1.5 mA
OL
REJ09B0098-0300