Ipv6 Nd Ra-Interval - Allied Telesis IE340 Series Command Reference Manual

IP 6 C
V OMMANDS
6 -
IPV ND RA INTERVAL

ipv6 nd ra-interval

Overview Use this command to specify the interval between IPv6 Router Advertisements
(RA) transmissions.
Use no parameter with this command to reset the value to the default value (600
seconds).
Syntax ipv6 nd ra-interval <seconds>
no ipv6 nd ra-interval
Default 600 seconds.
Mode Interface Configuration for a VLAN interface or a local loopback interface.
Usage notes To enable the transmission of router advertisements, you must apply the no
version of the
below.
Example To set the advertisements interval on vlan2 to be 60 seconds, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
To reset the advertisements interval on vlan2 to the default, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ipv6 nd minimum-ra-interval
commands
ipv6 nd suppress-ra
ipv6 nd prefix
C613-50631-01 Rev A
Parameter Description
<seconds>
Specifies the number of seconds between IPv6 Router
Advertisements (RAs). Valid values are from 4 to 1800 seconds.
ipv6 nd suppress-ra
configure terminal
interface vlan2
configure terminal
interface vlan2
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
command. This step is included in the example
ipv6 nd ra-interval 60
no ipv6 nd suppress-ra
no ipv6 nd ra-interval
976