IP
6 C
V
OMMANDS
6
-
IPV
ND RA
INTERVAL
ipv6 nd ra-interval
Overview
Use this command to specify the interval between IPv6 Router Advertisements
(RA) transmissions.
Use no parameter with this command to reset the value to the default value (600
seconds).
Syntax
ipv6 nd ra-interval <seconds>
no ipv6 nd ra-interval
Default
600 seconds.
Mode
Interface Configuration for a VLAN interface.
Usage
Advertisement flags will not be transmitted unless you have applied the
suppress-ra
Example
To set the advertisements interval on the VLAN interface "vlan4" to be 60 seconds,
use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related
ipv6 nd minimum-ra-interval
Commands
ipv6 nd suppress-ra
ipv6 nd prefix
C613-50170-01 Rev B
Parameter
Description
<seconds>
Specifies the number of seconds between IPv6 Router
Advertisements (RAs). Valid values are from 4 to 1800 seconds.
command as shown in the example below.
configure terminal
interface vlan4
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ipv6 nd ra-interval 60
no ipv6 nd suppress-ra
ipv6 nd
855