Ipv6 Nd Ra-Interval - Allied Telesis AT-IX5-28GPX Manual

IP 6 C
V OMMANDS
6 -
IPV ND RA INTERVAL

ipv6 nd ra-interval

Overview Use this command to specify the interval between IPv6 Router Advertisements
(RA) transmissions.
Use no parameter with this command to reset the value to the default value (600
seconds).
Syntax
ipv6 nd ra-interval <seconds>
no ipv6 nd ra-interval
Default 600 seconds.
Mode Interface Configuration for a VLAN interface.
Usage Advertisement flags will not be transmitted unless you have applied the
suppress-ra
Example To set the advertisements interval on the VLAN interface vlan4 to be 60 seconds,
use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ipv6 nd minimum-ra-interval
Commands
ipv6 nd suppress-ra
ipv6 nd prefix
680 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
<seconds>
Specifies the number of seconds between IPv6 Router
Advertisements (RAs). Valid values are from 4 to 1800 seconds.
command as shown in the example below.
configure terminal
interface vlan4
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
ipv6 nd ra-interval 60
no ipv6 nd suppress-ra
ipv6 nd
C613-50057-01 REV A