ADTRAN AOS Version R10.1.0 Command Reference Manual page 2580

Command Reference Guide
pppoe ac-name <name>
Use the pppoe ac-name command to identify the access controller (AC) with which AOS expects to
establish a Point-to-Point Protocol over Ethernet (PPPoE) session. Use the no form of this command to
return to the default setting.
Syntax Description
<name>
Default Values
By default, no AC is specified.
Command History
Release 5.1
Usage Examples
The following example identifies the AC with which AOS expects to establish a PPPoE session:
(config)#interface ppp 1
(config-ppp 1)#pppoe ac-name Access_Controller_Name
60000CRG0-35E
Specifies an AC by text string (up to 255 characters) corresponding to the
AC-Name Tag under RFC 2516. If this field is not specified, any AC is
acceptable. The AC value may be a combination of trademark, model, and
serial ID information (or simply the medium access control (MAC) address
of the unit).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
PPP Interface Command Set
2580