ADTRAN AOS Version R10.1.0 Command Reference Manual page 2567

Command Reference Guide
peer default ip address <ipv4 address>
Use the peer default ip address command to specify the default peer Internet Protocol version 4 (IPv4)
address of the remote end of this interface. Use the no form of this command to remove an assigned IPv4
address.
Syntax Description
<ipv4 address>
Default Values
By default, there is no assigned default peer IPv4 address.
Command History
Release 3.1
Functional Notes
This command is useful if the peer does not send the IPv4 address option during Point-to-Point Protocol
(PPP) negotiations.
Usage Examples
The following example sets the default peer IPv4 address to 192.22.71.50:
(config)#interface ppp 1
(config-ppp 1)#peer default ip address 192.22.71.50
60000CRG0-35E
Specifies the default peer IPv4 address for the remote end. IPv4 addresses
should be expressed in dotted decimal notation (for example, 10.10.10.1).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
PPP Interface Command Set
2567