ADTRAN AOS Version R10.1.0 Command Reference Manual page 2566

Command Reference Guide
media-gateway ip
Use the media-gateway ip command to associate an IP address source to use for Realtime Transport
Protocol (RTP) traffic. When configuring Voice over Internet Protocol (VoIP), RTP traffic must have an
IP address associated with it. However, some interfaces allow dynamic configuration of IP addresses,
causing this value to change periodically. Use the no form of this command to disable this function.
Variations of this command include:
media-gateway ip loopback <interface id>
media-gateway ip primary
media-gateway ip secondary <ip address>
Syntax Description
loopback <interface id>
primary
secondary <ip address>
Default Values
By default, media-gateway ip is disabled.
Command History
Release 10.1
Release 17.3
Usage Examples
The following example configures the unit to use the primary IP address for RTP traffic:
(config)#interface ppp 1
(config-ppp 1)#media-gateway ip primary
60000CRG0-35E
Specifies an IP address statically defined to a loopback interface for RTP
traffic. This is helpful when using a single IP address across multiple wide
area network (WAN) interfaces for RTP traffic. The valid range for loopback
interface identifiers is 1 to 1024. The interface ID is used to uniquely identify
a loopback interface. The entered value cannot be in use by another
loopback interface.
Specifies using this interface's configured primary IP address for RTP
traffic. Applies to static, Dynamic Host Configuration Protocol (DHCP), or
negotiated addresses.
Specifies using this interface's statically defined secondary IP address for
RTP traffic. IP addresses should be expressed in dotted decimal notation
(for example, 10.10.10.1).
Command was introduced.
Command was updated with the loopback interface indentification option.
Copyright © 2012 ADTRAN, Inc.
PPP Interface Command Set
2566