Set Priority - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

set priority

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
set priority priorityValue
no set priority
Command introduced in JunosE Release 8.2.0.
Configures a priority value for the <S, G>data stream. Dynamic multicast admission
control enables only prioritized groups to join the interface after the configured priority
limit is reached on the physical port. The system records the priority when a new <S, G>
entry is created. The no version removes the priority value.
priorityValue—Priority value for the <S, G> data stream; the default is 0
Route Map Configuration
Chapter 7: S Commands
507