Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual page 370

JunosE 11.3.x Command Reference Guide N to Z
Mode
328
ipv6-local-interface—Excluded by default; includes RADIUS attribute 26-46,
Ipv6-Local-Interface
ipv6-nd-ra-prefix—Excluded by default; includes RADIUS attribute 26-129,
Ipv6-NdRa-Prefix
ipv6-primary-dns—Excluded by default; includes RADIUS attribute 26-47,
Ipv6-Primary-DNS
ipv6-secondary-dns—Excluded by default; includes RADIUS attribute 26-48,
Ipv6-Secondary-DNS
ipv6-virtual-router—Excluded by default; includes RADIUS attribute 26-45,
Ipv6-Virtual-Router
l2tp-ppp-disconnect-cause—Includes RADIUS attribute 26-51, Disconnect-Cause
output-gigapkts—Includes RADIUS attribute 26-36, Acct-Output-Gigapackets
output-gigawords—Includes RADIUS attribute 53, Acct-Output-Gigawords
Attributes available for Access-Request, Acct-Start, Acct-Stop, Acct-On, and Acct-Off
messages:
nas-identifier—Includes RADIUS attribute 32, NAS-Identifier
Attributes available for Access-Request, Acct-On, and Acct-Off messages:
acct-session-id—Includes RADIUS attribute 44, Acct-Session-Id
Attributes available for Acct-Start, Acct-Stop, Acct-On, and Acct-Off messages:
event-timestamp—Includes RADIUS attribute 55, Event-Timestamp
Attributes available for Acct-On and Acct-Off messages only:
acct-authentic—Includes RADIUS attribute 45, Acct-Authentic
acct-delay-time—Includes RADIUS attribute 41, Acct-Delay-Time
Attributes available for Acct-Off messages only:
acct-terminate-cause—Includes RADIUS attribute 49, Acct-Terminate-Cause
access-request—Specifies RADIUS Access-Request messages
acct-on—Specifies RADIUS Acct-On messages
acct-off—Specifies RADIUS Acct-Off messages
acct-start—Specifies RADIUS Acct-Start messages
acct-stop—Specifies RADIUS Acct-Stop messages
enable—Enables attribute inclusion
disable—Disables attribute inclusion; the attribute is excluded
Global Configuration
Copyright © 2010, Juniper Networks, Inc.