Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide N to Z
neighbor advertise-map
Syntax
Release Information
Description
Options
Mode
24
[ no | default ] neighbor { ipAddress | ipv6Address | peerGroupName }
advertise-map advertiseMapName { exist-map | non-exist-map }
conditionMapName [ seq sequenceNumber ]
Command introduced in JunosE Release 9.0.0.
Specifies a peer or peer group within the current address family to which routes specified
by the first route map are advertised conditionally, depending on whether the second
route map is matched by some other routes in the BGP routing table. The no version
removes the conditions for advertising the routes to the peer or peer group. The default
version removes the explicit configuration from the peer or peer group and reestablishes
inheritance of the feature configuration.
ipAddress—IP address of BGP neighbor
ipv6Address—IPv6 address of BGP neighbor
peerGroupName—Name of a BGP peer group. If you specify a BGP peer group all the
members of the peer group inherit the characteristic configured with this command
advertiseMapName—Name of a route map that specifies the routes controlled by
conditional advertisement; no more than 50 advertise maps can be configured per
peer or peer group in an address-family
conditionMapName—Name of a route map that specifies the routes that control
conditional advertisement
sequenceNumber—Number, in the range 1–65535, that indicates the position an
advertise route map has in the list of advertise route maps configured for a particular
neighbor within the same address family; if the sequence number is not specified, the
position of the route map is considered to be the sum of the current largest sequence
number plus five
Address Family Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
