Set Priority - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

set priority

set priority priorityValue
Syntax
no set priority
Command introduced in JUNOSe Release 8.2.0.
Release Information
Configures a priority value for the <S, G>data stream. Dynamic multicast admission
Description
control enables only prioritized groups to join the interface after the configured
priority limit is reached on the physical port. The system records the priority when
a new <S, G> entry is created. The no version removes the priority value.
Options
Route Map Configuration
Mode
502
set priority
priorityValue Priority value for the <S, G> data stream; the default is 0