Path Ds1|E1 Clock Source - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

path ds1|e1 clock source

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
path pathChannel { ds1 | e1 } tributaryIdentifier clock source
{ line | internal { module | chassis } }
no path pathChannel { ds1 | e1 } tributaryIdentifier clock source
Command introduced before JunosE Release 7.1.0.
Configures the transmit clock source for DS1 or E1 channels over channelized SONET and
SDH interfaces. The no version restores the default value.
pathChannel—Number, in the range 1–2147483648, that identifies the path
tributaryIdentifier—Specifier for the tributary in the format
pathChannel { ds1 | e1 } pathPayload/tributaryGroup/tributaryNumber
pathPayload—Payload number for the path; value is 1 for SONET and in the range
1–3 for SDH
tributaryGroup—Number, in the range 1–7, that identifies the group within the path
tributaryNumber—Number of the tributary within the tributary group; the value is in
the range 1–4 if the tributary type is vt15 or tu11 and in the range 1–3 if the tributary
type is tu12
line—Interface transmits data from a clock recovered from the line's receive data
stream.
internal—Interface transmits data using its internal clock. You must specify one of the
following for internal clocking:
module—Internal clock is from the line module itself
chassis—Internal clock is from the configured system clock
Controller Configuration
Chapter 4: P Commands
139