Remote-Neighbor - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

remote-neighbor

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
For OSPF:
[ no ] remote-neighbor ipAddress area { areaId | areaIdInt }
For PIM:
[ no ] remote-neighbor [ ipAddress | ipv6Address ] sparse-mode
For RIP:
[ no ] remote-neighbor ipAddress
Command introduced before JunosE Release 7.1.0.
Configures an OSPF, PIM, or RIP remote neighbor. The no version removes the remote
neighbor and any attributes configured for the neighbor.
NOTE: For PIM, this command is typically used when you configure PIM
remote neighbors to run multicast services over BGP/MPLS VPNs. That
functionality is no longer supported.
ipAddress—IPv4 address identifying the remote neighbor
areaId—OSPF area ID in IP address format
areaIdInt—OSPF area ID as a decimal value, in the range 0–4294967295
ipv6Address—IPv6 address identifying the remote neighbor
Router Configuration
Chapter 6: R Commands
385