Nsf T2 - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

nsf t2

Syntax
Release Information
Description
Options
Mode
94
[ no ] nsf t2 { level-1 | level-2 } [ seconds ]
Command introduced before JunosE Release 7.1.0.
Specifies the maximum amount of time, in seconds, that an IS-IS restarting router waits
for the LSP database to synchronize. You must configure separate instances of the T2
timer for each IS-IS level at which the router operates. The no version restores the default
T2 wait time, 30 seconds.
level-1—Sets the T2 wait time independently for level 1 routing
level-2—Sets the T2 wait time independently for level 2 routing
seconds—Maximum wait time, in the range 5–120 seconds, for LSP database
synchronization; default value is 30 seconds
Router Configuration
Copyright © 2010, Juniper Networks, Inc.