Path Ds1 Fdl Carrier - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

path ds1 fdl carrier

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] path pathChannel ds1 tributaryIdentifier fdl carrier
Command introduced before JunosE Release 7.1.0.
Specifies that a DS1 signal is used in the carrier environment. This command applies to
a DS1 over channelized SONET or SDH interface. The no version restores the default
situation, in which an interface does not operate in the carrier environment.
pathChannel—Number, in the range 1–2147483648, that identifies the path
tributaryIdentifier—Specifier for the tributary in the format
pathChannel { ds1 | e1 } pathPayload/tributaryGroup/tributaryNumber
pathPayload—Payload number for the path; value is 1 for SONET and in the range
1–3 for SDH
tributaryGroup—Number, in the range 1–7, that identifies the group within the path
tributaryNumber—Number of the tributary within the tributary group; the value is in
the range 1–4 if the tributary type is vt15 or tu11 and in the range 1–3 if the tributary
type is tu12
Controller Configuration
Chapter 4: P Commands
147