Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide N to Z
path ds3 t1 timeslots
Syntax
Release Information
Description
Options
Mode
176
path pathChannel ds3 ds3Channel t1 t1Channel/subchannel timeslots range
[ speed { 56 | 64 } ]
no path pathChannel ds3 ds3Channel t1 t1Channel/subchannel
Command introduced before JunosE Release 7.1.0.
Assigns a range of DS0 timeslots to a subchannel as a single data stream for a T1 channel
on a DS3 signal. This command applies to a T1 channel on a DS3 over channelized SONET
interface. You can optionally specify a line speed that applies to all DS0 timeslots assigned
to a subchannel. The no version deletes the fractional T1 circuit.
pathChannel—Number, in the range 1–2147483648, that identifies the path
ds3Channel—Number, in the range 1–3, that identifies the DS3 channel
t1Channel—Number, in the range 1–28, that identifies the T1 channel
subchannel—Fractional T1 interface, in the range 1–24
range—Timeslots assigned to the T1 channel in the range 1–24; a dash represents a
range of timeslots, and a comma separates timeslots. For example, 1-10, 15-18 assigns
timeslots 1–10 and 15–18.
speed—Specifies the data rate for the T1 channel, either 56 Kbps or 64 Kbps; default
value is 64 Kbps
Controller Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
