Shaping-Rate - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

shaping-rate

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
shaping-rate shapingRate [ operator operandValue ]* [ bps | kbps ]
[ burst burstSize [ milliseconds | bytes ] ]
shaping-rate operandValue [ operator operandValue ]* [ bps | kbps ]
no shaping-rate
Command introduced before JunosE Release 7.1.0.
milliseconds and bytes keywords added in JunosE Release 7.1.0.
bps and kbps keywords added in JunosE Release 8.0.0.
Sets the shaping rate and burst size. The no version deletes the shaping rate.
shapingRate—Constant shaping rate in bits per second or kilobits per second; in the
range 1–1000000000 bps/kbps. You can set the shaping rate to vary from 1 bps to
1000 gbps (which is denoted by entering 1000000000 kbps in the CLI for this
command).
operator—Mathematical function
operandValue—Input for the operator; can be a QoS parameter definition name or an
integer
*—Indicates that one or more parameters can be repeated multiple times in a list in
the command line
bps—Specifies shaping rate in bits per second
kbps—Specifies shaping rate in kilobits per second
NOTE: The lower and higher limits for the shaping rate range apply to both
the bps and kbps keywords available with this command. For example, if
you want to set the shaping rate to 1 mbps, you can either enter 1000 as
the value for the shapingRate argument and suffix it with the kbps keyword,
or enter 1000000 as the value for the shapingRate argument and suffix it
with the bps keyword. Both the methods of configurations result in the
same shaping rate value to be set.
burstSize—Number, in the range 0–522240 (0–510 KB); 0 enables the router to select
an applicable default value
milliseconds—Specifies burst size in milliseconds
bytes—Specifies burst size in bytes
Scheduler Profile Configuration
Chapter 7: S Commands
515