Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide N to Z
profile atm1483 bulk-config-name pvc
Syntax
Release Information
Description
Options
Mode
276
profile atm1483 bulk-config-name bulkConfigName pvc vpi vci overrideProfileName
no profile atm1483 bulk-config-name bulkConfigName pvc vpi vci
Command introduced before JunosE Release 7.1.0.
Assigns an overriding profile to a single ATM PVC that exists within a VC subrange
previously configured with the atm bulk-config command. The profile atm1483
bulk-config-name pvc command enables you to troubleshoot the specified PVC by
overriding the currently assigned base profile with one that has debugging attributes
enabled. After the overriding profile is assigned, it is used instead of the previously assigned
base profile to create any ATM 1483 dynamic subinterface columns over the specified
PVC. The no version removes the overriding profile assignment for the PVC and restores
the original base profile assignment.
bulkConfigName—Name associated with the VC range configured for use by a dynamic
ATM 1483 subinterface, as specified in the atm bulk-config command
vpi—Virtual path identifier of the PVC; must exist between the starting VPI value and
ending VPI value of a bulk-configured VC subrange
vci—Virtual circuit identifier of the PVC; must exist between the starting VCI value and
ending VCI value of a bulk-configured VC subrange
overrideProfileName—Name of the profile that overrides the previously assigned base
profile for the specified ATM PVC
Interface Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
