Path Ds1 Fdl Transmit - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

path ds1 fdl transmit

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] path pathChannel ds1 tributaryIdentifier fdl transmit
{ path-id | idle-signal | test-signal }
no path pathChannel ds1 tributaryIdentifier fdl transmit
Command introduced before JunosE Release 7.1.0.
Configures the router to send the specified FDL message on a DS1 signal. This command
applies to a DS1 over channelized SONET or SDH interface. The no version stops the
router from sending the specified FDL message or all FDL messages.
pathChannel—Number, in the range 1–2147483648, that identifies the path
tributaryIdentifier—Specifier for the tributary in the format
pathChannel { ds1 | e1 } pathPayload/tributaryGroup/tributaryNumber
pathPayload—Payload number for the path; value is 1 for SONET and in the range
1–3 for SDH
tributaryGroup—Number, in the range 1–7, that identifies the group within the path
tributaryNumber—Number of the tributary within the tributary group; the value is in
the range 1–4 if the tributary type is vt15 or tu11 and in the range 1–3 if the tributary
type is tu12
path-id—Transmits a path identification message every second; default value is disabled
idle-signal—Transmits an idle signal message every second; default value is disabled
test-signal—Transmits a test signal message every second; default value is disabled
Controller Configuration
Chapter 4: P Commands
149