Path Ds3 Mdl String - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

path ds3 mdl string

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
path pathChannel ds3 ds3Channel mdl string { eic eicValue | fic ficValue |
generator genValue | lic licValue | pfi pfiCode | port portValue | unit unitValue }
no path pathChannel ds3 ds3Channel mdl string { eic | fic | generator | lic | pfi |
port | unit }
Command introduced before JunosE Release 7.1.0.
Allows you to configure an MDL message on a DS3 signal as defined in the ANSI
T1.107a-1990 specification. This command applies to a DS3 over channelized SONET
interface. The no version restores the default value to the specified MDL message or to
all MDL messages.
pathChannel—Number, in the range 1–2147483648, that identifies the path
ds3Channel—Number, in the range 1–3, that identifies the path
eicValue—Equipment identification code; 1–10 characters; default value is the null
value
ficValue—Frame identification code; 1–10 characters; default value is the null value
genValue—Generator number to send in the MDL test signal message; 1–38 characters;
default value is the null value
licValue—Line identification code; 1–11 characters; default value is the null value
pfiCode—Facility identification code to send in the MDL path message; 1–38 characters;
default value is the null value
portValue—Equipment port number to send in the MDL idle signal message; 1–38
characters; default value is the null value
unitValue—Unit identification code; 1–6 characters; default value is the null value
Controller Configuration
Chapter 4: P Commands
159