Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual page 757

Description
Options
Copyright © 2010, Juniper Networks, Inc.
rtMemNlri variable replaced by rtfPrefix variable in JunosE Release 9.1.0.
Displays the routes in the Adj-RIBs-Out table of the specified peer or peer group. For
peers, displays routes that have been previously advertised to the peer and the attributes
for the routes before the application of outbound policy.
For peer groups, displays routes that will be advertised to the peer group, but includes
the full set of route attributes associated with the routes after the application of outbound
policy. This command returns an error message unless you first enable rib-out with the
no neighbor rib-out disable command or the no rib-out disable command.
ipv4 unicast—Specifies the IPv4 unicast address family and routing table; the default
option
ipv4 multicast—Specifies the IPv4 multicast address family and routing table
vpnv4 all—Specifies the IPv4 VPN address family and all IPv4 VPN routing and
forwarding instances
vpvn4 vrf vrfName—Specifies the IPv4 VPN address family and only the IPv4 VPN
routing and forwarding instance with the name vrfName
l2vpn all—Displays information for only the L2VPN address family; the all keyword is
optional unless you specify a site ID and block offset
route-target signaling—Specifies the route-target address family
ipAddress—IP address of a neighbor whose routes the router has learned
ipv6Address—IPv6 address of a neighbor whose routes the router has learned
peerGroupName—Name of a BGP peer group
route-target-filter neighbor—Displays routes actually advertised to the specified peer
group member (neighbor); which routes are advertised is determined by the application
of the route-target filter received from that neighbor to routes in the peer group's
Adj-RIBs-Out table
ipRtfNbrAddress—IP address of a peer group member that has advertised route-target
membership filtering information
ipv6RtfNbrAddress—IPv6 address of a peer group member that has advertised
route-target membership filtering information
network—Route that best matches this IP address; if no network is specified, displays
the fields for all networks
networkMask—Address mask to be applied to the network address
longer-prefixes—Displays all routes with a prefix that is equal to or more specific than
the specified prefix
siteId—Numerical identifier for the site; must be an unsigned 16-bit integer greater than
zero that is unique across the VPLS domain
blockOffset—Integer in the range 1–65535 that identifies a block offset for which
information is displayed
Chapter 7: S Commands
715