Neighbor Rib-Out Disable - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

neighbor rib-out disable

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no | default ] neighbor { ipAddress | ipv6Address | peerGroupName } rib-out disable
Command introduced before JunosE Release 7.1.0.
ipv6Address variable added in JunosE Release 8.0.0.
Disables storage of routes to the Adj-RIBs-Out table (disables rib-out) for the neighbor
or peer group. Storage is disabled by default. The no version enables the route storage.
The default version removes the explicit configuration from the peer or peer group and
reestablishes inheritance of the feature configuration.
NOTE: If you enable or disable rib-out for a peer or peer group and this action
changes the current configuration, the peer session or all peer group sessions
are automatically bounced.
ipAddress—IP address of BGP neighbor; you can independently enable or disable the
Adj-RIBs-Out table for a peer, regardless of whether it is a member of a peer group
ipv6Address—IPv6 address of BGP neighbor; you can independently enable or disable
the Adj-RIBs-Out table for a peer, regardless of whether it is a member of a peer group
peerGroupName—Name of a BGP peer group. If you specify a BGP peer group by using
the peerGroupName argument, a single Adj-RIBs-Out table is established for the peer
group; BGP does not enable individual Adj-RIBs-Out tables for each peer group member.
Address Family Configuration, Router Configuration
Chapter 2: N Commands
57