Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide N to Z
ppp multilink enable
Syntax
Release Information
Description
Mode
230
[ no ] ppp multilink enable
Command introduced before JunosE Release 7.1.0.
Enables creation of dynamic MLPPP interfaces when used in a profile. The no version
causes the LNS to reject any incoming requests to establish dynamic MLPPP interfaces.
Profile Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 and is the answer not in the manual?