Path Ds3 Loopback - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

path ds3 loopback

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
path pathChannel ds3 ds3Channel loopback { local | network { line | payload } }
no path pathChannel ds3 ds3Channel loopback
[ no ] path pathChannel ds3 ds3Channel loopback remote
Command introduced before JunosE Release 7.1.0.
Configures a loopback at the DS3 layer for a DS3 signal. This command applies to a DS3
over channelized SONET interface. The no version turns off the loopback.
pathChannel—Number, in the range 1–2147483648, that identifies the path
ds3Channel—Number, in the range 1–3, that identifies the path
local—Loops the data back toward the router; on supported line modules also sends
an alarm indication signal (AIS) out toward the network.
network { line | payload }—Specify the line keyword to loop the data toward the network
before the data reaches the framer. Specify the payload keyword to loop the data
toward the network after the framer has processed the data.
remote—Sends a far end alarm code in the C-bit framing, as defined in ANSI T1.404,
to notify the remote end to activate or (when you use the no version) deactivate the
line loopback
Controller Configuration
Chapter 4: P Commands
157