Neighbor Remote-As - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

neighbor remote-as

Syntax
Release Information
Description
Options
Mode
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
neighbor { ipAddress | ipv6Address | peerGroupName } remote-as number
no neighbor { ipAddress | ipv6Address } [ remote-as [ number ] ]
no neighbor peerGroupName remote-as [ number ]
Command introduced before JunosE Release 7.1.0.
ipv6Address variable added in JunosE Release 8.0.0.
Adds an entry to the BGP neighbor table. Specifying a neighbor with an AS number that
matches the AS number specified in the router bgp command identifies the neighbor as
internal to the local AS. Otherwise, the neighbor is considered external. This command
takes effect immediately. The no version removes an entry from the table.
ipAddress—IP address of BGP neighbor
ipv6Address—IPv6 address of BGP neighbor
peerGroupName—Name of a BGP peer group. If you specify a BGP peer group by using
the peerGroupName argument, all the members of the peer group inherit the
characteristic configured with this command, unless it is overridden for a specific peer.
number—Number in the range 1–4294967295; the AS to which the neighbor belongs
Address Family Configuration, Router Configuration
Configuring BGP Signaling for L2VPNs and Configuring BGP Signaling for VPLS in the
JunosE BGP and MPLS Configuration Guide
Chapter 2: N Commands
55