JunosE 11.3.x Command Reference Guide N to Z
path ds3 t1 fdl transmit
Syntax
Release Information
Description
Options
Mode
170
[ no ] path pathChannel ds3 ds3Channel t1 t1Channel fdl transmit
{ path-id | idle-signal | test-signal }
no path pathChannel ds3 ds3Channel t1 t1Channel fdl transmit
Command introduced before JunosE Release 7.1.0.
Configures the router to send the specified type of FDL message for a T1 channel on a
DS3 signal. This command applies to a T1 channel on a DS3 over channelized SONET
interface. The no version stops the router from sending the specified type of FDL message
or all FDL messages.
pathChannel—Number, in the range 1–2147483648, that identifies the path
ds3Channel—Number, in the range 1–3, that identifies the DS3 channel
t1Channel—One or more individual T1 channels, ranges of T1 channels, or combination
of individual channels and ranges, in the range 1–28 (no spaces); for example,
3,7-15,19-13,27
path-id—Transmits a path identification message every second; default value is disabled
idle-signal—Transmits an idle signal message every second; default value is disabled
test-signal—Transmits a test signal message every second; default value is disabled
Controller Configuration
Copyright © 2010, Juniper Networks, Inc.