Table of Contents
Advertisement
show ip pim remote-neighbor
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
show ip pim remote-neighbor [ ipAddress ] [ count ] [ filter ]
Command introduced before JunosE Release 7.1.0.
Displays information about all PIM remote neighbors or the specified remote neighbor.
NOTE: This command is typically used when you configure PIM remote
neighbors to run multicast services over BGP/MPLS VPNs. That functionality
is no longer supported.
ipAddress—IP address of a remote neighbor
count—Display the number of remote neighbors
filter—See Filtering show Commands on page 4
Privileged Exec
Chapter 7: S Commands
847
Advertisement
Table of Contents
