JunosE 11.3.x Command Reference Guide N to Z
set ip next-hop
Syntax
Release Information
Description
Options
Mode
496
set ip next-hop { ipAddress | interface interfaceType interfaceSpecifier |
peerAddress }
no set ip next-hop [ ipAddress | peerAddress]
Command introduced before JunosE Release 7.1.0.
Indicates where to send packets that pass a match clause of a route map for policy
routing. The no version removes the set clause from a route map.
NOTE: Beginning with JunosE Release 7.1.0, this command is not supported
for route maps used by the table-map command.
ipAddress—IP address of next hop to which packets are sent; does not need to be an
adjacent router
interfaceType—Interface type; see Interface Types and Specifiers on page 5
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
peerAddress—On outbound route maps, disables the next hop-calculation by setting
the next hop to the IP address of the BGP speaker; on inbound route maps, overrides
any third-party next-hop configuration by setting the next hop to the IP address of the
peer
Route Map Configuration
Copyright © 2010, Juniper Networks, Inc.