Pppoe Sessions - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

pppoe sessions

Syntax
Release Information
Description
Options
Mode
256
pppoe sessions sessions
no pppoe sessions
Command introduced before JunosE Release 7.1.0.
Specifies the number of subinterfaces permitted on a PPPoE interface. The command
affects only subinterfaces that are created after the command is entered. Previously
created interfaces remain, even if their number exceeds the new value of the parameter.
The no version restores the default value, 8000 (ERX routers) and 16,000 (E120 and
E320 routers). For ES2 10G ADV LM, the default value is 32,000 (E120 and E320 routers).
sessions—Number of subinterfaces permitted on the interface in the range 1–8000
(ERX routers) or 1–32,000 (E120 and E320 routers). On the ES2 10G ADV LM (E120
and E320 routers), you can have PPPoE subinterfaces in the range 1–32,000. The
default value is 8000 (ERX routers) or 16,000 (E120 and E320 routers). For ES2 10G
ADV LM, the default value is 32,000 (E120 and E320 routers).
NOTE: The number of subinterfaces permitted on the interface for E120
and E320 routers is in the range 1–32,000 irrespective of the type of line
module. However, if you specify a value greater than the number of
subinterfaces supported by a line module, the number of subinterfaces
created is the default maximum value for that line module. For example,
if you specify the number of subinterfaces for a ES2 4G LM as 32,000
interfaces, the number of subinterfaces created is 16,000, which is the
default maximum value for the ES2 4G LM.
Interface Configuration, Profile Configuration, Subinterface Configuration
Copyright © 2010, Juniper Networks, Inc.