Receive-Interface - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

receive-interface

Syntax
Release Information
Description
Options
Mode
362
receive-interface interfaceType interfaceSpecifier
no receive-interface
Command introduced before JunosE Release 7.1.0.
Specifies the interface on which the RTR probe expects to receive responses. You must
set this attribute when multiple RTR entries are configured to use the same target address.
Specifying a receiving interface enables the router to map incoming RTR responses to
the proper RTR entry, even when multiple RTR entries have the same target address.
The no version restores the default value, which is to receive a response on any interface.
interfaceType—Interface type; see Interface Types and Specifiers on page 5
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
RTR Configuration
Copyright © 2010, Juniper Networks, Inc.