Redistribute Isis Ip - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

redistribute isis ip

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] redistribute isis ip { level-1 into level-2 | level-2 into level-1 }
{ distribute-list accessListName | route-map mapTag }
Command introduced before JunosE Release 7.1.0.
Redistributes routes from one IS-IS routing level into the other. You must specify either
an IP access list or a route map to define the IS-IS routes to be redistributed. The no
version ends the redistribution.
level-1—Specifies the redistribution of routes from or into IS-IS level 1
level-2—Specifies the redistribution of routes from or into IS-IS level 2
accessListName—String of up to 32 alphanumeric characters specifying the IP access
list used to filter routes between levels
mapTag—String of up to 32 alphanumeric characters specifying the route map applied
to all routes from the source protocol; if you do not specify a route map, all routes are
redistributed
Router Configuration
Chapter 6: R Commands
369