Path Ds3 Snmp Trap Link-Status - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

path ds3 snmp trap link-status

Syntax
Release Information
Description
Options
Mode
162
[ no ] path pathChannel ds3 ds3Channel snmp trap link-status
Command introduced before JunosE Release 7.1.0.
Enables SNMP link status processing for a DS3 signal. This command applies to a DS3
over channelized SONET interface. The no version disables SNMP link status processing
on an interface.
pathChannel—Number, in the range 1–2147483648, that identifies the path
ds3Channel—Number, in the range 1–3, that identifies the path
Controller Configuration
Copyright © 2010, Juniper Networks, Inc.