Neighbor Send-Label - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

neighbor send-label

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] neighbor { ipAddress | ipv6Address | peerGroupName } send-label
Command introduced before JunosE Release 7.1.0.
ipv6Address variable added in JunosE Release 8.0.0.
Configures a neighbor to distribute an MPLS label with its IPv4 and IPv6 route
advertisements. This command enables BGP to dynamically negotiate SAFI 1 and SAFI
4 with this neighbor. In Router Configuration mode, the command has the same effect
as if it were issued in the context of the IPv4 unicast address family. The no version
removes the configuration.
ipAddress—IP address of BGP neighbor
ipv6Address—IPv6 address of BGP neighbor
peerGroupName—Name of a BGP peer group. If you specify a BGP peer group by using
the peerGroupName argument, all the members of the peer group inherit the
characteristic configured with this command. You cannot override the characteristic
for a specific member of the peer group.
Address Family Configuration, Router Configuration
Chapter 2: N Commands
61