Table of Contents
Advertisement
profile-reassign
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
profile-reassign atm interfaceSpecifier { ppp | pppoe | any } profileName
Command introduced before JunosE Release 7.1.0.
Reassigns the profile currently assigned to the specified encapsulation type for the
specified ATM 1483 subinterface. For troubleshooting purposes, the profile-reassign
command enables you to " swap" the currently assigned profile for one that has PPP or
PPPoE packet–logging attributes enabled. There is no no version.
NOTE: Issuing the profile-reassign command causes the router to tear down
any dynamic interfaces that exist above the ATM 1483 subinterface. After
the profile is reassigned, the router restores the interfaces based on the
necessary client reconnections.
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
ppp—Specifies a PPP encapsulation type to which the profile applies
pppoe—Specifies a PPPoE encapsulation type to which the profile applies
any—Specifies any autoconfigured encapsulation that does not have a specific profile
assignment; valid only if neither the ppp encapsulation type nor the pppoe
encapsulation type has an existing profile assignment
profileName—Profile name of up to 80 characters
Privileged Exec (at privilege level 5 or higher)
Chapter 4: P Commands
277
Advertisement
Table of Contents
