Pppoe Auto-Configure - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

pppoe auto-configure

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
pppoe auto-configure [ lockout-time { minValue maxValue | none } ]
no pppoe auto-configure
Command introduced before JunosE Release 7.1.0.
lockout-time keyword, minValue variable, maxValue variable, and none keyword added
in JunosE Release 7.2.0.
Configures the router to dynamically create PPPoE subinterfaces over static PPPoE major
interfaces. Optionally, specifies the lockout time range for the PPPoE clients associated
with the dynamic PPPoE subinterface column on the PPPoE major interface. The no
version terminates dynamic creation of PPPoE subinterfaces on the static PPPoE major
interface.
minValue—Minimum lockout time, in the range 1–86400 seconds (24 hours)
maxValue—Maximum lockout time, in the range 1–86400 seconds (24 hours)
none—Disables lockout for the PPPoE clients associated with the dynamic PPPoE
subinterface column on the static PPPoE major interface; this is the default value
Interface Configuration, Subinterface Configuration
Chapter 4: P Commands
243