Pvc - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

pvc

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
To create a control PVC from Interface Configuration mode:
pvc vcd vpi/vci ilmi
no pvc vcd
To create a data PVC from Subinterface Configuration mode and access ATM VC
Configuration mode:
pvc vcd vpi/vci
no pvc vcd
Command introduced in JunosE Release 7.1.0.
From Interface Configuration mode, creates a control PVC that supports ILMI services.
To create a control PVC, you must specify the VCD, VPI, VCI, and the ilmi encapsulation
type. The no version removes the specified control PVC from the router.
From Subinterface Configuration mode, creates a data PVC and accesses ATM VC
Configuration mode, from which you can configure and modify individual PVC attributes
one at a time. To create a data PVC, you must specify the VCD, VPI, and VCI. The no
version removes the specified data PVC from the router.
vcd—Virtual circuit descriptor that is an identifier for the VC in other commands; number,
in the range 1–2147483647
vpi—Virtual path identifier for this PVC. The numeric range depends on the module
capabilities and current configuration.
vci—Virtual circuit identifier for this PVC. The numeric range depends on the module
capabilities and current configuration. For control PVCs, the recommended VCI value
is 16 for ilmi encapsulation and 5 for qsaal encapsulation. The VCI value cannot be 0.
ilmi—Configures Integrated Local Management Interface encapsulation for a control
PVC
Interface Configuration, Subinterface Configuration
Chapter 4: P Commands
287