Neighbor Filter-List - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

neighbor filter-list

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
To apply an access list:
neighbor { ipAddress | ipv6Address | peerGroupName } filter-list
accessListName { in | out }
no neighbor { ipAddress | ipv6Address | peerGroupName } filter-list
[ accessListName ] { in | out }
To assign a weight:
neighbor { ipAddress | ipv6Address | peerGroupName } filter-list
accessListName weight value
no neighbor { ipAddress | ipv6Address | peerGroupName } filter-list
[ accessListName ] weight [ value ]
Command introduced before JunosE Release 7.1.0.
ipv6Address variable added in JunosE Release 8.0.0.
Applies an AS path access list to advertisements inbound from or outbound to the
specified neighbor, or assigns a weight to incoming routes that match the AS path access
list. The no version stops the application of the list or assignment of the weight.
ipAddress—IP address of BGP neighbor
ipv6Address—IPv6 address of BGP neighbor
peerGroupName—Name of a BGP peer group. If you specify a BGP peer group by using
the peerGroupName argument, all the members of the peer group inherit the
characteristic configured with this command, unless it is overridden for a specific peer.
accessListName—Name of a single AS path access list; string of up to 32 characters
in—Applies access list to incoming routes (inbound policy)
out—Applies access list to outgoing routes (outbound policy); you cannot configure a
member of a peer group to override the inherited peer group characteristic for outbound
policy
value—Number in the range 0–65535; assigns relative importance to incoming routes
matching AS paths
Address Family Configuration, Router Configuration
Chapter 2: N Commands
37