Ospf Log-Adjacency-Changes - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

ospf log-adjacency-changes

Syntax
Release Information
Description
Options
Mode
118
[ no ] ospf log-adjacency-changes
[ severity { severityValue | severityNumber } ] [ verbosity verbosityLevel ]
Command introduced before JunosE Release 7.1.0.
Configures the router to send a system log message when the state of an OSPFv2 neighbor
changes. For OSPFv3 neighbors, use the log-adjacency-changes command. The no
version turns off this feature.
severity—Minimum severity of the log messages displayed for the selected category;
described either by a descriptive term—severityValue—or by a corresponding
number—severityNumber—in the range 0–7; the lower the number, the higher the
priority:
emergency or 0—System unusable
alert or 1—Immediate action needed
critical or 2—Critical condition exists
error or 3—Error condition
warning or 4—Warning condition
notice or 5—Normal but significant condition
info or 6—Informational message
debug or 7—Debug message
verbosityLevel—Specifies the verbosity of the log category's messages; can be any of
the following:
low—Terse
medium—Moderate detail
high—Verbose
Router Configuration
Copyright © 2010, Juniper Networks, Inc.