Reserve-Bandwidth - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

reserve-bandwidth

Syntax
Release Information
Description
Options
Mode
390
reserve-bandwidth { 90 | 80 | 50 }
no reserve-bandwidth
Command introduced in JunosE Release 11.2.0.
Directs the router to reserve a percentage of the total bandwidth for forwarding on a
shared server port. The remaining bandwidth is used for tunnel processing. The default
bandwidth percentage reserved for forwarding is 90. The no version reserves the default
percentage of the total bandwidth, 90.
NOTE: This command is supported only for the ES2 10G ADV LM when
configured in shared server mode. It is not supported on other line modules
that support tunnel server configuration.
90—Sets the percentage of reservable bandwidth on a shared server port for forwarding
to 90. The remaining 10 percent is used for tunnel processing. This is the default option.
80—Sets the percentage of reservable bandwidth on a shared server port for forwarding
to 80. The remaining 20 percent is used for tunnel processing.
50—Sets the percentage of reservable bandwidth on a shared server port for forwarding
to 50. The remaining 50 percent is used for tunnel processing.
Tunnel Server Configuration
Copyright © 2010, Juniper Networks, Inc.