JunosE 11.3.x Command Reference Guide N to Z
neighbor
Syntax
Release Information
Description
Options
Mode
22
For ANCP:
[ no ] neighbor neighborName
For OSPF:
neighbor ipAddressOspf [ pollinterval seconds | priority number ]
no neighbor ipAddressOspf [ pollinterval | priority ]
For RIP:
[ no ] neighbor ipAddressRip
Command introduced before JunosE Release 7.1.0.
For ANCP, creates an ANCP neighbor and accesses the L2C Neighbor Configuration
(config-l2c-neighbor) mode. For OSPF, configures OSPF neighbors on an NBMA network.
For RIP, specifies a RIP neighbor to which the router sends unicast messages. The no
version removes the specified neighbor configuration or, by omitting the neighbor name,
all ANCP neighbor configurations (ANCP), removes the neighbor (OSPF and RIP), or
restores the default values (OSPF).
neighborName—Name of the ANCP neighbor
ipAddressOspf—IP address of the neighbor's interface; this interface must itself be
configured for the NBMA network type
number—Router priority value of the neighbor in the range 1–4294967295; default
value is 0
seconds—Interval in seconds at which the neighbor is polled; should be much larger
than the hello interval (per RFC 1247); in the range 0–255; default value is 120
ipAddressRip—IP address of the neighbor's interface; this interface must be defined as
a passive interface with the passive-interface command
Address Family Configuration (RIP), Router Configuration
Copyright © 2010, Juniper Networks, Inc.