Path Ds1|E1 Framing - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

path ds1|e1 framing

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
path pathChannel { ds1 | e1 } tributaryIdentifier framing framingType
no path pathChannel { ds1 | e1 } tributaryIdentifier framing
Command introduced before JunosE Release 7.1.0.
Configures the framing format for a DS1 or an E1 signal when DS1/E1 is configured over
channelized SONET and SDH interfaces. The no version restores the default value.
pathChannel—Number, in the range 1–2147483648, that identifies the path
tributaryIdentifier—Specifier for the tributary in the format
pathChannel { ds1 | e1 } pathPayload/tributaryGroup/tributaryNumber
pathPayload—Payload number for the path; value is 1 for SONET and in the range
1–3 for SDH
tributaryGroup—Number, in the range 1–7, that identifies the group within the path
tributaryNumber—Number of the tributary within the tributary group; the value is in
the range 1–4 if the tributary type is vt15 or tu11 and in the range 1–3 if the tributary
type is tu12
framingType—One of the following types:
crc4—Cyclic redundancy check (default for E1); not available for T1
no-crc4—No cyclic redundancy check; not available for T1
esf—Extended superframe (T1 default); not available for E1
sf—Superframe; not available for E1
Controller Configuration
Chapter 4: P Commands
141