Qos-Shaping-Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

qos-shaping-mode

Syntax
Release Information
Description
Options
Mode
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
[ no ] qos-shaping-mode [ cell | frame ]
Command introduced before JunosE Release 7.1.0.
Specifies either cell-based or frame-based traffic shaping for ATM, Gigabit Ethernet, or
10-Gigabit Ethernet interfaces. The shaping mode is configured for a major interface and
affects scheduling for all nodes and queues stacked above the interface. In cell shaping
mode, queues and nodes are scheduled as if they were ATM cells. All newly configured
ports use the shaping mode from port 0; frame is the default shaping mode for port 0.
If you do not specify an option, the command restores the default, frame. The no version
restores the default, frame.
cell—Shapes traffic based on the number of bytes in a cell, and accounts for ATM cell
encapsulation and padding overhead
frame—Shapes traffic based on the number of bytes in a frame, without considering
cell encapsulation and padding overhead; the default shaping mode for port 0
Interface Configuration
Configuring the QoS Shaping Mode for ATM Interfaces
Configuring the QoS Shaping Mode for Ethernet Interfaces
Chapter 5: Q Commands
301