Path Ds3 T1 Fdl String - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

path ds3 t1 fdl string

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
path pathChannel ds3 ds3Channel t1 t1Channel fdl string { eic eicValue | fic ficValue | lic
licValue | unit unitValue | pfi pfiValue | port portValue |
generator generatorValue }
no path pathChannel ds3 ds3Channel t1 t1Channel fdl string { eic | fic | lic | unit | pfi | port
| generator }
Command introduced before JunosE Release 7.1.0.
Defines an FDL message for a T1 channel on a DS3 signal, as defined in the ANSI T1.403
specification. This command applies to a T1 channel on a DS3 over channelized SONET
interface. Currently, FDL strings can only be configured locally. The no version restores
the default value to the specified FDL message or to all FDL messages.
pathChannel—Number, in the range 1–2147483648, that identifies the path
ds3Channel—Number, in the range 1–3, that identifies the DS3 channel
t1Channel—One or more individual T1 channels, ranges of T1 channels, or combination
of individual channels and ranges, in the range 1–28 (no spaces); for example,
3,7-15,19-13,27
eicValue—Equipment identification code; 1–10 characters; default value is the null
value
ficValue—Frame identification code; 1–10 characters; default value is the null value
licValue—Line identification code; 1–10 characters; default value is the null value
unitValue—Unit identification code; 1–6 characters; default value is the null value
pfiValue—Facility identification code to send in the FDL path message; 1–38 characters;
default value is the null value
portValue—Equipment port number to send in the FDL idle signal message; 1–38
characters; default value is the null value
generatorValue—Generator number to send in the FDL test signal message; 1–38
characters; default value is the null value
Controller Configuration
Chapter 4: P Commands
169