Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual page 409

Mode
Copyright © 2010, Juniper Networks, Inc.
ospf match—Determines what type(s) of routes to redistribute from OSPF; all OSPF
routes are redistributed if you do not specify a type
internal—Redistributes OSPF internal routes
external 1—Redistributes OSPF external routes of metric-type 1
external 2—Redistributes OSPF external routes of metric-type 2
absoluteValue—Metric that is applied to all routes from the source protocol, in the
range 0–4294967295; in BGP this value is the MED, which defaults to the IGP metric
of the redistributed route
mapTag—String of up to 32 alphanumeric characters that specifies a route map applied
to all routes from the source protocol; all routes are redistributed if you do not specify
a route map
wtValue—Administrative weight (relative importance) for routes redistributed into the
protocol; a number, in the range 0–65535
level-1—Specifies the redistribution of routes into only IS-IS level 1
level-1-2—Specifies the redistribution of routes into both IS-IS level 1 and level 2
level-2—Specifies the redistribution of routes into only IS-IS level 2; this is the default
behavior
metric-type—Specifies the OSPF or IS-IS metric type for all routes from the source
protocol
For routes redistributed into IS-IS:
metric-type external—Only the metric of the route itself is considered for comparison
metric-type internal—Both the metric of the route and the cost to the router that
advertised the route are considered for comparison; this is the IS-IS default
For routes redistributed into OSPF:
metric-type 1—Cost of the external routes is equal to the sum of all internal costs
and the external cost
metric-type 2—Cost of the external routes is equal to the external cost alone; this is
the OSPF default
tagValue—Tag that is applied to all routes from the source protocol, in the range
0–4294967295
*—Indicates that one or more parameters can be repeated multiple times in a list in
the command line
Address Family Configuration, Router Configuration
Chapter 6: R Commands
367