Set Metric-Type - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

set metric-type

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
set metric-type atMetric
no set metric-type
Command introduced before JunosE Release 7.1.0.
Sets the metric type for the destination routing protocol. The no version removes the set
clause from a route map.
atMetric—Specifies the metric type from the following choices:
For BGP:
external—Reverts to the normal BGP rules for propagating the MED; this is the BGP
default
internal—Sets the MED of a received route that is being propagated to an external
peer equal to the IGP cost of the indirect next hop
For IS-IS:
external—Only the metric of the route itself is considered for comparison
internal—Both the metric of the route and the cost to the router that advertised the
route are considered for comparison; this is the IS-IS default
For OSPF:
1—Cost of the external routes is equal to the sum of all internal costs and the external
cost
2—Cost of the external routes is equal to the external cost alone; this is the OSPF
default
Route Map Configuration
Chapter 7: S Commands
503