Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual page 776

JunosE 11.3.x Command Reference Guide N to Z
Mode
Related
Documentation
734
asNumber—AS number for origin of route target information, in the range
1–4294967295
extendedCommunity—Two-part number in the format number1:number2 that identifies
an extended community of VPNs, in the format number1 : number2, where:
number1—Autonomous system (AS) number, in the range 1–4294967295, or an
IP address
number2—Unique integer, in the range 1–4294967295; 32 bits if number1 is a 16-bit
AS number; 16 bits if number1 is an IP address or a 32-bit AS number
prefixLength—Number that specifies the length of the route prefix, in the range 32–96
rtfAddress—rtfPrefix with a prefix length of 96; representing the route-target
membership NLRI (RT-MEM-NLRI), in the format asNumber : extendedCommunity (for
example, 320:320:524 or 320:50.2.3.4:524)
l2vpn all—Specifies all VPLS and VPWS instances in the L2VPN address family
l2vpn vpls vplsName—Specifies the VPLS instance with the name vplsName
l2vpn vpws vpwsName—Specifies the VPWS instance with the name vpwsName
siteId—Numerical identifier for the site; must be an unsigned 16-bit integer greater than
zero that is unique across the VPLS domain
blockOffset—Integer in the range 1–65535 that identifies a block offset for which
information is displayed
filter—See Filtering show Commands on page 4
Privileged Exec, User Exec
See Monitoring BGP-Related Settings for L2VPNs in JunosE BGP and MPLS Configuration
Guide
Copyright © 2010, Juniper Networks, Inc.