Path Ds1|E1 Description - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

path ds1|e1 description

Syntax
Release Information
Description
Options
Mode
140
path pathChannel { ds1 | e1 } tributaryIdentifier [ tributaryType ] description name
no path pathChannel { ds1 | e1 } tributaryIdentifier [ tributaryType ] description
Command introduced before JunosE Release 7.1.0.
Assigns a text description or an alias to a DS1 or an E1 signal. This command applies to
a DS1/E1 over SONET/SDH VT layer on channelized SONET and SDH interfaces. Use the
show controllers sonet command to display the text description. The no version removes
the description or alias.
pathChannel—Number, in the range 1–2147483648, that identifies the path
tributaryIdentifier—Specifier for the tributary in the format
pathChannel { ds1 | e1 } pathPayload/tributaryGroup/tributaryNumber
pathPayload—Payload number for the path; value is 1 for SONET and in the range
1–3 for SDH
tributaryGroup—Number, in the range 1–7, that identifies the group within the path
tributaryNumber—Number of the tributary within the tributary group; the value is in
the range 1–4 if the tributary type is vt15 or tu11 and in the range 1–3 if the tributary
type is tu12
tributaryType—Virtual tributary type
vt15—Default for SONET DS1 tributaries
tu11—Default for SDH DS1 tributaries
tu12—Default for SDH E1 tributaries
name—Text string or alias of up to 80 characters for the T1/E1 over SONET/SDH VT
layer on channelized SONET and SDH interfaces
Controller Configuration
Copyright © 2010, Juniper Networks, Inc.